vicidial.org

good day !!

I hope you can help me with this problem have a multi server VICIDIAL installed with ViciBox Redux version v.4.0.3, VERSION: 2.6-393a, BUILD: 130124-1721

the configuration is as follows:
server database DELL R720 12 processors, 32 GB RAM, 2 hard drives 600 Gb SAS 15K in RAID 1,
server slave database of the same characteristics
6 telephony servers DELL R320, 16 GB RAM, 2 hard drive 500gb SATA.
1 website R720, 16 processors, 16 GB RAM, 1 1TB hard drive.

have 280 signed agents in the system, work without problem taking calls until they have to for some reason have to change
its status ready to pause for recess or training for example, when the database is loaded queries with a status of "Waiting for table level lock" which
load on the server generates and encourages the system until the agents can not do anything on the web until the queries go, often i have to restart mysql and repair the databa base asterisk
so they can work again ..

any ideas?

If you have 280 agents, you need to be using an LSI Logic MegaRAID caching RAID controller. A Dell PERC card or LSI Logic chipset only doesn't count. We've been through this many times, and I can assure you it works.

Thanks Matt , could you help me with a little more information about the cards please find what follows but not if whatever it may serve me:

MegaRAID SAS 9271-8i
Cache Protection for RAID Controller Cards - Protect against data loss during power failure

That one should work,

http://www.lsi.com/products/raid-contro ... 71-8i.aspx

Hello.
finally we gain an LSI SAS 9271-8i card Megaraid could configure the server and install Vicidial all ran fine until I began consultations breaks climbed load and the application was no longer functional is glued , any ideas? Anything else I should set in megaraid card or any parameters in the configuration files ?? I hope you can help me .