Asterisk Reload error

[kddacraker]

Hi when I am trying to reload the asterisk I got following on cli,

please let me know what may be the reason the asterisk is not reloading same about sip and zap too,

Thanks,

voip*CLI> reload
Apr 21 18:18:08 NOTICE[1890]: cdr.c:1214 do_reload: CDR simple logging enabled.
Apr 21 18:18:08 NOTICE[1890]: dnsmgr.c:338 do_reload: Managed DNS entries will be refreshed every 300 seconds.
Apr 21 18:18:08 NOTICE[1890]: indications.c:505 ast_unregister_indication_country: Removed default indication country 'us'
Apr 21 18:18:08 NOTICE[1890]: pbx_dundi.c:451 reset_global_eid: No ethernet interface found for seeding global EID You will have to set it manually.
Apr 21 18:18:08 WARNING[1890]: chan_zap.c:11062 setup_zap: Ignoring switchtype
Apr 21 18:18:08 WARNING[1890]: chan_zap.c:11062 setup_zap: Ignoring signalling
Apr 21 18:18:08 WARNING[1890]: chan_zap.c:11062 setup_zap: Ignoring rxwink
voip*CLI> reload chan_sip.so
voip*CLI> reload chan_zap.so
Apr 21 18:20:02 WARNING[1890]: chan_zap.c:11062 setup_zap: Ignoring switchtype
Apr 21 18:20:02 WARNING[1890]: chan_zap.c:11062 setup_zap: Ignoring signalling
Apr 21 18:20:02 WARNING[1890]: chan_zap.c:11062 setup_zap: Ignoring rxwink
voip*CLI>


calls are not going as well I can not see the calls status from CLI also please guide me,

Thanks,

KD

[mflorell]

Asterisk version?

astguiclient version?

using default VICIDIAL conf files?

[kddacraker]

Here is the information

asterisk : 1.2.24

astguiclient : 2.0.4

and using default files only,

If you can specify and particular file if necessary I will pate the contains,

Thanks,

[mflorell]

What kind of telco lines are you using?

[kddacraker]

Hello matt,

I didnt got the meaning of telco line,

But I have installed it on a webserver (Harpertown E5405 2.0GHz)

with 2 GB ram and 10 MBPS uplink,

My sip provider is voipshop,

At agents ent we have 2MBPS 1:1 Line

Please let me know if you need any other information

Thanks

[mflorell]

Well, there are no fatal errors if you aren't using telco lines. So what's the functional problem you are having?

[kddacraker]

Yes there are no error messages,

But the calls are not going through... even if there is any problem in line it should show calls on CLI but my leads are unused. Again I uploaded new set but same issue . I am not sure why this happen as it was working fine till last friday.

the main thing is why the asterisk is not loading as I am giving reload command as well as sip channels and zap...

[mflorell]

Are there leads in the hopper?

What is the output of 'screen -ls' in Linux?

[speed]

hello ,

make a power off wait 1 min.. and then power on.

i had the same problem and only a restart or reboot is not enough.

but after power off the error is no longer exists.


cu speed