[Jun 14 12:01:47] NOTICE[4204]: chan_dahdi.c:10518 pri_dchannel: PRI got event: HDLC Bad FCS (8) on Primary D-channel of span 1
[Jun 14 12:01:47] NOTICE[4204]: chan_dahdi.c:10518 pri_dchannel: PRI got event: HDLC Abort (6) on Primary D-channel of span 1
repeat and repeat...
error message in Asterisk CLI mode
Moderators: gerski, enjay, williamconley, Op3r, Staydog, gardo, mflorell, MJCoate, mcargile, Kumba, Michael_N
3 posts
• Page 1 of 1
error message in Asterisk CLI mode
by jiteshright » Sat Jun 14, 2014 1:40 am
VICIDIAL VERSION: 2.4-364a BUILD: 120409-1136
Asterisk 1.4.39.1
OS- GoAutoDial 3.0
Digium card
Asterisk 1.4.39.1
OS- GoAutoDial 3.0
Digium card
- jiteshright
- Posts: 22
- Joined: Fri May 23, 2014 4:02 am
Re: error message in Asterisk CLI mode
by geoff3dmg » Sun Jun 15, 2014 4:35 am
HDLC Bad FCS means the checksum was wrong. Check your cables and hardware (eg do a loopback test). If that comes back ok, then the fault is probably at the telco end.
Vicibox 5.03 from .iso | VERSION: 2.10-451a BUILD: 140902-0816 | Asterisk 1.8.28.2-vici | Multi-Server | Amfeltec H/W Timing Cards | No Extra Software After Installation | Dell PowerEdge 1850 | Pentium 4 'Prescott' Xenon Quad @ 3.40GHz
- geoff3dmg
- Posts: 403
- Joined: Tue Jan 29, 2013 4:35 am
- Location: Lancashire, UK
Re: error message in Asterisk CLI mode
by jiteshright » Sat Jun 21, 2014 5:28 am
yes, i got the solution....this problem with PRI line...
PRI line up down issue.....
the issue has been resolve...
PRI line up down issue.....
the issue has been resolve...
VICIDIAL VERSION: 2.4-364a BUILD: 120409-1136
Asterisk 1.4.39.1
OS- GoAutoDial 3.0
Digium card
Asterisk 1.4.39.1
OS- GoAutoDial 3.0
Digium card
- jiteshright
- Posts: 22
- Joined: Fri May 23, 2014 4:02 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 119 guests