Inbound not working for Amazon

[arunabh]

Hi,

This is Arunabh from India. We are running two outbound processes and I am looking after the vicidial server. The outbound is running fine and good, but the issue is with the inbound DID call landing because we are going to run one for sale Amazom process where customers will call into our purchased DID number.

I have configured the Inbound DID,In-group and campaign following thoroughly the managers manual, but the confusion is with carrier configuration.

Following is the inbound carrier details:

[testcarrier23492]
disallow=all
allow=ulaw
allow=g729
type=friend
username=DialitesInbound
fromuser=DialitesInbound
secret=Di&thy8dh2487
host=103.94.86.53
context=trunkinbound
insecure=port,invite
dtmfmode=rfc2833
usecallerid=yes
trustrpid=no
sendrpid=yes
requirecalltoken=no
nat=yes

Global String:

TESTSIPTRUNK23492=SIP/testcarrier23492

Dialplan Entry:

exten => _492.,1,AGI(agi://127.0.0.1:4577/call_log)
exten => _492.,2,Dial(${TESTSIPTRUNK23492}/${EXTEN:3},,tTor)
exten => _492.,3,Hangup

I am using vicibox 7
Version : 2.14-718a

As I am new to setup inbound campaign please suggest.

I have tried the following dial plan but it is not working:

exten => DID-number,1,Ringing
exten => DID-number,2,Wait(1)
exten => DID-number,3,Answer
exten => DID-number,4,AGI(agi://127.0.0.1:4577/call_log)
exten => DID-number,5,AGI(agi-DID_route.agi)
exten => DID-number,6,Hangup

The issue is that when agents logged in campaign and I called the DID it is not landing.
DID: All USA
DID No: 12xxxxx6003

I have called the DID from different connection and Skype also but the result is the same.

Please suggest as I need to complete it ASAP.

And please suggest me where I should put the dialprefix ? Is that same as outbound ?

[ambiorixg12]

First thing you need to do it is enable the asterisk sip de bug and verify if the INVITE request from the DID provider is reaching your server sip set debug on

[ed123]

Hi,, you just post your sip credentials and everyone can see it..hope its a dummy one..

[williamconley]

There are TWO basic steps for inbound:

First you must set the carrier to send the calls to your server. This can't be done in Vicidial, although "Registration" of the Vicidial server may be part of the process. To test for this you can use sip debug or an asterisk console to see if you get ANY activity in the console or the sip debug during a call attempt.

The second step is to set the inbound carrier in Vicidial to have "context=trunkinbound" in the Account Settings. This will turn control of the call over to the Vicidial scripting/call handling system. This puts the call into the "[trunkinbound]" context in extensions.conf. The only purpose of that context is to route the call to the Vicidial agi scripts. There is NO need or use to creating your own dialplan for an inbound call since that's NOT vicidial and you obviously want to use Vicidial.

Happy Hunting!

PS: Moving this Support question to the Support board where it belongs.