problem while dialing

[rudra_ach]

Hi ,

I'm getting following error

We are running vicidial dialer .We are using g729 codec.But while dialing if we do show g729 it is showing a huge diffrence between number of coder/decoder in raio.The decoder is much higher than codec.we have installed 60 g729 licences and 10 agents are using.After this state asterisk stops automatically after some time.I'm pasting few errors I captured at that time.

Anather thing we have reduced the number of conference from 200 to 24 as we have 24 agents working on the dialer.It is creating the problem.

Feb 14 05:18:52 WARNING[12636]: app_meetme.c:1556 conf_run: Unable to write frame to channel: Success
Feb 14 05:18:52 WARNING[12636]: app_meetme.c:1556 conf_run: Unable to write frame to channel: Success
Feb 14 05:18:52 WARNING[12636]: app_meetme.c:1556 conf_run: Unable to write frame to channel: Success


Feb 14 05:18:54 WARNING[12636]: app_meetme.c:1556 conf_run: Unable to write frame to channel: Success
-- Created MeetMe conference 1020 for conference '8600054'
Feb 14 05:18:54 WARNING[14108]: app_meetme.c:295 careful_write: Failed to write audio data to conference: Bad file descriptor
Feb 14 05:18:54 WARNING[14108]: app_meetme.c:295 careful_write: Failed to write audio data to conference: Bad file descriptor


Feb 14 05:18:54 WARNING[14108]: app_meetme.c:785 conf_free: Conference not found
Feb 14 05:18:54 WARNING[14108]: app_meetme.c:785 conf_free: Conference not found
Feb 14 05:18:54 WARNING[14108]: chan_zap.c:2311 zt_hangup: Asked to hangup channel not connected
Feb 14 05:18:54 WARNING[14108]: chan_zap.c:2311 zt_hangup: Asked to hangup channel not connected
Feb 14 05:18:54 WARNING[14108]: channel.c:897 ast_channel_free: Unable to find channel in list
Feb 14 05:18:54 WARNING[14108]: channel.c:897 ast_channel_free: Unable to find channel in list
Feb 14 05:18:54 WARNING[12824]: file.c:587 ast_readaudio_callback: Failed to write frame
Feb 14 05:18:54 WARNING[12824]: file.c:587 ast_readaudio_callback: Failed to write frame
dialer*CLI>

[Op3r]

are you using ztdummy?

when I use ztdummy I get that flood on the asterisk cli.


if you are using x100p look at your zaptel.conf or zapata.conf

[rudra_ach]

While dialing,

I'm getting these errors also.
regards
rudra

Feb 15 01:47:08 WARNING[11434]: channel.c:529 ast_channel_alloc: Channel allocation failed: Refusing due to active shutdown
Feb 15 01:47:08 WARNING[11434]: channel.c:529 ast_channel_alloc: Channel allocation failed: Refusing due to active shutdown