vicidial.org

Hello Sir,

I know this is a wrong forum for this but i need an answer for this:

I have installed slackware 10.2 by using sata.i for installation

after the installation is done and reboot it says Kernel Panic: VFS: Unable to mount root fs and hang. i also created bootdisk for this. i also tried mount boot=/dev/sda 1 to 3

how can i edit my lilo.conf as the system hangs.

my pc has 2 sata

please help me...

When you instaled did you select sata.i as the mount image?

yes..

on installation i use sata.i

and it works fine and also it installed everything.

but when im trying to boot it is the error..

Not sure what to tell you. If you select the sata.i boot image at the end of the installation process it should boot up just fine. I have never had a problem with that on the SATA servers I've installed on.

Now it works here is what i used:

1. first time, dont boot with default kernel, when the first cd asks for kernel specify sata.i

2. after installation, in the configuration part where u are again asked to specify the kernel . at this time chose sata.i from the first cd.

And it works well.. thanks thanks =D