vicidial.org

Hi,

I have a problem with call backs. Almost all of callbacks finished with the "error: call rejected: Busy, cause: 21 Busy".
I'm afraid that I'have the same problem in new lead campaign, where 20% new lead have status Busy.
Can anybody help me??

Best regards
Wojtek

1) Welcome to the Party!

2) when you post, please post your entire configuration including (but not limited to) your installation method and vicidial version with build.

this IS a requirement for posting along with reading the stickies (at the top of each forum) and the manager's manual (available on EFLO.net, both free and paid versions)

You should also post: Asterisk version, telephony hardware (model number is helpful here), cluster information if you have one, and whether any other software is installed in the box. If your installation method is "from scratch" you must post your operating system and should also post the .iso version from which you installed your original operating system. If your installation is "Hosted" list the site name of the host.

If this is a "Cloud" or "Virtual" server, please note the technology involved along with the version of that techology (ie: VMware Server Version 2.0.2). If it is not, merely stating the Motherboard model # and CPU would be helpful.

Similar to This:

Vicibox X.X from .iso | Vicidial X.X.X-XXX Build XXXXXX-XXXX | Asterisk X.X.X | Single Server | No Digium/Sangoma Hardware | No Extra Software After Installation | Intel DG35EC | Core2Quad Q6600

3) Perhaps it would help if you were to show us a sample of the asterisk command line output from one of these calls?

Hello there,

I have seen this ISDN cause code mainly after calling a mobile phone were the called person simply rejects the call....


I googled this:

Cause No. 21 - call rejected.
This cause indicates that the equipment sending this cause does not wish to accept this call. although it could have accepted the call because the equipment sending this cause is neither busy nor incompatible. This cause may also be generated by the network, indicating that the call was cleared due to a supplementary service constraint. The diagnostic field may contain additional information about the supplementary service and reason for rejection.
What it means:
This is usually a telco issue. The call never reaches the final destination, which can be caused by a bad switch translation, or a misconfiguration on the equipment being called.

Best regards
Fram