Page 1 of 1

nice to meet everyone

PostPosted: Wed Aug 30, 2006 6:50 am
by anshu
pletely saturated and furthermore have The use of donor cells in M-phase may mediate and its unconjugated form consti
the assay will be specificfor theintended p16 protein is an early step toward ma- Drug Evaluation and Research, Rockville
Really what difference does it make unless you need to sell your airplane? And even then compare the amount of decrease in your retirement accounts or house to the perceived decrease in the value of
oh yeah, when you're at the store they seem a little pricey at $6-8 a pop, especially when you can get cheapo ones for $4-$5 But they are soooo amazingly good, like a little reward for yourself, whil

PostPosted: Wed Aug 30, 2006 7:10 am
by mflorell
It is very difficult to debug Slackware boot issues remotely. Can you post the last output that shows up before boot fails?

Operating system can't boot

PostPosted: Wed Aug 30, 2006 8:24 am
by anshu
hello sir ,
Operting system is not boot.grab problem.tere is problem to boot the hard disk.

how to configure lilo file

thanks

re: how to configure lilo file

PostPosted: Wed Aug 30, 2006 9:05 am
by anshu
Hello Sir/Mam
I have aproblem please short out that problem how to configue lilo file in slackware10.2.

how to configure lilo file
thanks

Back to top

PostPosted: Wed Aug 30, 2006 9:48 am
by Cald
Hello,

Did you follow the scratch install( http://astguiclient.sourceforge.net/scr ... stall.html )?

It contains detailed instructions on configuring lilo during the setup and also on how to modify /etc/lilo.conf if you recompiled the kernel.

Good luck!
Marcos

Re: problem to install slackware 10.2

PostPosted: Thu Aug 31, 2006 1:25 am
by anshu
Hello Sir.
Idiscussed my problem to you yesterday.but i could not find out solution.
during the installation i configue all the things but there arrive a error to configue lilo file.
I followed all the scrach instruction to install slackware.

Lilo Install Error
Sorry, but the attempt to install lilo has returned an error, so LILO has not been correctly installed.


Please suject me how to configue lilo file.please give me righit solution to sortout my problem.

Thanks
]

PostPosted: Thu Aug 31, 2006 9:00 am
by Cald
Run `liloconfig` and follow the instructions.

Good luck!
Marcos