Page 1 of 1
alternative digium card?
Posted:
Wed Feb 14, 2007 1:33 pmby mel0683
hi guys
what alternative digium card aside to this one?Digium Wildcard Single Span T1 Card T100P..
thank u.
beginner
Posted:
Wed Feb 14, 2007 10:24 pmby mflorell
The T100P has been retired, and the replacement is the TE110P.
The alternatives to using Digium cards are Sangoma a101 and Rhino single T1 card.
Posted:
Thu Feb 15, 2007 2:04 pmby mel0683
how about X100P?this specs Asterisk OEM X100P FXO PCI Card
co'z i purchased this device.its possible to run in vicidial?
thanks
Posted:
Thu Feb 15, 2007 3:31 pmby mflorell
The X100P card is only an analog POTS line card, not a T1/E1 card. But if you just need a timer for zaptel/meetme, it will work very well.
Posted:
Thu Feb 15, 2007 6:09 pmby mel0683
really its only used for timer of zaptel/meetme only?
so what device can i use to setup a vicidial to have a predictive dialer?
Posted:
Fri Feb 16, 2007 12:10 amby mflorell
For only a timer, then the X100P card will work great. I recommend getting them on ebay or x100p.com
DIALOGIC CARDS
Posted:
Wed Mar 07, 2007 5:51 pmby eijal
What about dialogic cards?
I have one, but I only found that it works with special drivers from DIGIUM (paying). I was looking how to buy that driver, but I can't find anything.
Anyone has experience with this cards (just for timer) my model is: D/41JCT-LS.
PD.
I want to use it only like a timer
Posted:
Wed Mar 07, 2007 6:23 pmby Op3r
Just buy an x100p for your timer needs. its cheap it cost like 15 to 30 usd
Posted:
Thu Mar 08, 2007 12:22 pmby eijal
Op3r wrote:Just buy an x100p for your timer needs. its cheap it cost like 15 to 30 usd
I have a x100p card, but the problem is that it doesn't feet on my PCI 3.3v interfaces. And it's too expensive to buy a E1/T1 card from DIGIUM, just for timer
Posted:
Thu Mar 08, 2007 2:37 pmby gerski
Why not use an old pc (p3 or older) and use ur x100p if ur just trying to install it. that way it is much cheaper than buying a T1/E1 card...
Posted:
Thu Mar 08, 2007 2:48 pmby Op3r
or change your motherboard.
Posted:
Thu Mar 08, 2007 4:26 pmby eijal
I can't use a P3 or an old motherboard, because I am designing a predictive dialer for 15 agent. And imposible that a P3 or an old motherboard can support that load
Posted:
Thu Mar 08, 2007 8:41 pmby Op3r
then buy a new motherboard.
a new motherboard only cost like 300 usd (which is a very good one)