Page 1 of 1
can't open goautodial admin page via ip address on browser
Posted:
Fri May 23, 2014 4:11 amby jiteshright
i have successfully installed 64bit version and setup IP on NIC card, (no DGM card installed)
but still i can't open goautodial admin page through IP address..
DGM card must installed to open this OR some other packages are installed to open this ??
Re: can't open goautodial admin page via ip address on brows
Posted:
Fri May 23, 2014 1:38 pmby tarundas
Digium card is not needed. I think it's a networking problem ( I hope you have installed GoAutodial properly and configured the NIC). Can you ping your dialer from your client machines ?
Re: can't open goautodial admin page via ip address on brows
Posted:
Sat May 24, 2014 1:29 amby jiteshright
yes i can receive the packets....
"yum update" command is not running....
[Errno 4] IOError: <urlopen error (-3, 'Temporary failure in name resolution')>
Error: Cannot find a valid baseurl for repo: base
Re: can't open goautodial admin page via ip address on brows
Posted:
Sat May 24, 2014 3:24 pmby tarundas
Please post details of your ifcfg-xxxx and resolv.conf files
Re: can't open goautodial admin page via ip address on brows
Posted:
Mon May 26, 2014 1:41 amby jiteshright
where can i find it....??
Re: can't open goautodial admin page via ip address on brows
Posted:
Sat Jun 21, 2014 5:35 amby jiteshright
overall we can say...that this goautodial has so many bugs....some time it's working some time it's not working...
the best way to use dial method from scratch installation of vicidial in centos...