Page 1 of 1

error message in Asterisk CLI mode

PostPosted: Sat Jun 14, 2014 1:40 am
by jiteshright
[Jun 14 12:01:47] NOTICE[4204]: chan_dahdi.c:10518 pri_dchannel: PRI got event: HDLC Bad FCS (8) on Primary D-channel of span 1
[Jun 14 12:01:47] NOTICE[4204]: chan_dahdi.c:10518 pri_dchannel: PRI got event: HDLC Abort (6) on Primary D-channel of span 1

repeat and repeat...

Re: error message in Asterisk CLI mode

PostPosted: Sun Jun 15, 2014 4:35 am
by geoff3dmg
HDLC Bad FCS means the checksum was wrong. Check your cables and hardware (eg do a loopback test). If that comes back ok, then the fault is probably at the telco end.

Re: error message in Asterisk CLI mode

PostPosted: Sat Jun 21, 2014 5:28 am
by jiteshright
yes, i got the solution....this problem with PRI line...
PRI line up down issue.....
the issue has been resolve...
:)