vicidial.org

I have setup a clustered load balancing setup of Vicidial (3 Single Server setup of ViciBox.i686-4.0.1 ISO)
Server 1 (Asterisk & Apache), Server 2 (Mysql), Server 3 (Asterisk)

2 Port Digium PRI card configured (E1) on server 1 & 3 (All together 120 ports - 4 PRI lines used)

Now the problem that i am facing is that i am unable to configure DIDs of PRI lines used on Server 3

I am using the same GUI of Server 1 to configure the DID as Apache on Server 3 is diabled.

Where am i going wrong?

__________________________________________________________________
Specs:
Server 1 (Asterisk & Apache)
ViciBox.i686-4.0.1
IBM-X3100-m4
NTEL XEON QUAD CORE PROCESSOR 2.4 GHZ OR 3 GHZ
HDD 1 TB
RAM 8 GB
Digium, Inc. Wildcard TE220 dual-span T1/E1/J1 card 3.3V (PCI-Express) (5th gen) (rev 02)

Server 2 (Mysql)
ViciBox.i686-4.0.1
IBM-X3100-m4
NTEL XEON QUAD CORE PROCESSOR 2.4 GHZ OR 3 GHZ
HDD 1 TB
RAM 8 GB

Server 3 (Asterisk)
ViciBox.i686-4.0.1
IBM-X3100-m4
NTEL XEON QUAD CORE PROCESSOR 2.4 GHZ OR 3 GHZ
HDD 1 TB
RAM 8 GB
Digium, Inc. Wildcard TE220 dual-span T1/E1/J1 card 3.3V (PCI-Express) (5th gen) (rev 02)

any advice?

Resolved....!!!