Can't access Web log in, when typing dialler's in address.
Posted: Sun Sep 27, 2015 6:50 pm
I recently plugged in a dialler I made about 2 years ago.
Was set up perfectly, worked a treat.
But switched it on to get my carrier settings for a new dialler, and it's as though there's nothing on the network, chrome says there's no such page...
I'm expecting the "please wait while I redirect you" Message. ..
But I can ssh and winscp just fine...
And the server loads up otherwise as expected.
Any ideas? Thanks...
Edit:
The only thing I want from the dialler is my carrier settings.
I've got my original usr/pw, it's mainly the dial plan I need.
So when searching via winscp, I found that the extentions.confirm had a few defaulty-looking ones, but I did a ctrl-f search for the word orbtalk, my username, and my pw separately, hoping it would take me to "my" dial plan. But the text want there.
I 'know' this machine, I set it up... it's literally never been used since I provisioned it, and I made successful calls on it...
So confused...
Was set up perfectly, worked a treat.
But switched it on to get my carrier settings for a new dialler, and it's as though there's nothing on the network, chrome says there's no such page...
I'm expecting the "please wait while I redirect you" Message. ..
But I can ssh and winscp just fine...
And the server loads up otherwise as expected.
Any ideas? Thanks...
Edit:
The only thing I want from the dialler is my carrier settings.
I've got my original usr/pw, it's mainly the dial plan I need.
So when searching via winscp, I found that the extentions.confirm had a few defaulty-looking ones, but I did a ctrl-f search for the word orbtalk, my username, and my pw separately, hoping it would take me to "my" dial plan. But the text want there.
I 'know' this machine, I set it up... it's literally never been used since I provisioned it, and I made successful calls on it...
So confused...