Page 1 of 1
Zap Channel is never hung up
Posted:
Wed May 23, 2007 11:10 amby AlexR
Hello Matt et All!
I've been trying to set up an outbound campaign, (Asterisk 1.2.17, AGC 2.3.5b) It works fine... but if the far side of the call never hangs up, he stays in the meetme room of the agent even if some other call is passed. Any advice on this?
Greetings,
Alejandro
Posted:
Wed May 23, 2007 11:19 amby mflorell
What kind of Zap channel?
Asterisk version?
Asterisk CLI output?
Posted:
Wed May 23, 2007 11:29 amby ramindia
Hi
is far end Client behind NAT ?
ram
Posted:
Wed May 23, 2007 11:44 amby AlexR
Thanks Matt and ramindia
Version: Asterisk 1.2.17
Zap Channel: TE412P Quad E1 Card with HWEC
Vicidal 2.0.3b5
CLI output i will post in a few mins, we have to set up a test case (load leads, etc)
Thank you!
Posted:
Sun Jun 03, 2007 8:24 amby badboy2
AlexR wrote:Thanks Matt and ramindia
Version: Asterisk 1.2.17
Zap Channel: TE412P Quad E1 Card with HWEC
Vicidal 2.0.3b5
CLI output i will post in a few mins, we have to set up a test case (load leads, etc)
Thank you!
In my system calls doesnt hang up too. I receive:
Noone is in your session 8000051
Go back
Call Agent again
evey 5-15 seconds in all agents.
Posted:
Sun Jun 03, 2007 9:28 amby badboy2
Hi! while browsing the forum I found the answer! Many thanks to ytcracker! My asterisk_live_channel got corrupted.. anyway everything works now. Cheers!
PostPosted: Wed May 02, 2007 4:24 pm Post subject: no one is in your session after power outage/power off .... by ytcracker