cyberkyd wrote:I've tried that already but no success.
That's a little vague: Are you saying the calls were not sent to the agent? That would be "SUCCESS" for extension 8368. The purpose of 8368 is to send a call to an availble agent upon ANSWER signal from the carrier.
cyberkyd wrote:i didn't get the calls to leave voicemail.
8368 sends the call to the agent. The agent is then responsible for leaving the voicemail OR pushing the "VM" button in the Transfer-Conf pane (two steps: Push Transfer-conf, then VM). This only leaves a message on the answering machine if properly configured in the Campaign settings for AMD/Voicemail.
cyberkyd wrote:Plus i couldn't hear the calls ringing. I've dial ratio set to one.
Agents ONLY hear calls ringing if the call is Manual dial. The entire Vicidial system is built around autodial and sending calls to available agents (or other scripted pathways) after the call is ANSWERED. Until the ANSWER, nothing happens. Obviously that means the agent never hears ringing.
Also worthy of note: In many scenrios it's the caller's telephone that supplies the "ringing" sound. Vicidial does not provide this because there's nobody there to listen, it's an autodialer. Thus in many cases even if you could listen during that part of the call, there would be no ringing. This is often a problem during manually dialed calls, as Vicidial does not provide that artificial ringing sound when it receives the "ringing" signal from the carrier.cyberkyd wrote:Your response is much appreciated.
carpenox has helped a freakin' lot of people.