vicidial.org

I wanted to if the manager.conf settings listed below are correct. Should [Mark], Premit, Deny, and Secret be commented? Thanks

; AMI - The Asterisk Manager Interface
;
; Third party application call management support and PBX event supervision
;
; This configuration file is read every time someone logs in
;
; Use the "show manager commands" at the CLI to list available manager commands
; and their authorization levels.
;
; "show manager command <command>" will show a help text.
;
; ---------------------------- SECURITY NOTE -------------------------------
; Note that you should not enable the AMI on a public IP address. If needed,
; block this TCP port with iptables (or another FW software) and reach it
; with IPsec, SSH, or SSL vpn tunnel
;

;[mark]
;secret = mysecret
;deny=0.0.0.0/0.0.0.0
;permit=209.16.236.73/255.255.255.0
;
; If the device connected via this user accepts input slowly,
; the timeout for writes to it can be increased to keep it
; from being disconnected (value is in milliseconds)
;
; writetimeout = 100
;
; Authorization for various classes
;read = system,call,log,verbose,command,agent,user
;write = system,call,log,verbose,command,agent,user

[general]
enabled = yes
port = 5038
bindaddr = 0.0.0.0
displayconnects = yes
[cron]
secret = 1234
read = system,call,log,verbose,command,agent,user
write = system,call,log,verbose,command,agent,user
[updatecron]
secret = 1234
read = command
write = command
[listencron]
secret = 1234
read = system,call,log,verbose,command,agent,user
write = command
[sendcron]
secret = 1234
read = command
write = system,call,log,verbose,command,agent,user

Short answer yes