Page 1 of 1
Unable to write frame to channel: Success
Posted:
Tue Oct 10, 2006 1:25 pmby mati
Hi,
In my asterisk log I constantly get "app_meetme.c: Unable to write frame to channel: Success". It is ~ 200 message per sec. I don't find that this warning causes any trouble, exept bigger log file.
Posted:
Tue Oct 10, 2006 3:31 pmby gschaller
Do you use DTF tones? Try "soft hangup Local/85" <TAB> (press the tab key) and look for the channels. I have a cronjob for this problem. It searches for the DTMF channels, wait some seconds and kill them with "soft hangup".
Posted:
Tue Oct 10, 2006 3:35 pmby mati
No I don't use DTMF.
Posted:
Tue Oct 10, 2006 3:40 pmby mflorell
What zaptel timer are you using?
Posted:
Tue Oct 10, 2006 3:54 pmby mati
I use digium clone with 4e1 ports. I synchronize with E1 from my telecom.
Posted:
Tue Oct 10, 2006 7:52 pmby mflorell
What kind of digium clone?
I have had bad luck with most of them, except for Sangoma which work great.
Posted:
Wed Oct 11, 2006 1:17 amby mati
Tormenta 2. It works ok, sometimes agents reports echo.
Posted:
Wed Oct 11, 2006 1:25 amby mflorell
What version of Asterisk are you using?
Posted:
Wed Oct 11, 2006 1:42 amby mati
asterisk 1.2.11 and 1.2.12.1, both with the same problem
Posted:
Wed Oct 11, 2006 6:40 amby mflorell
There were a lot of changes after 1.2.10, try 1.2.10 and see if that helps. Also try an older version of zaptel.