Getting an error when executing ztcfg -vv command

[mtk_400]

I am facing an error when i try to install a sangoma a101 E1 card with vicibox/vicidial now server..Sip connectivity is fine...but facing a problem in zap.

zaptel_hardware
pci:0000:05:05.0 wanpipe- 1923:0040 Sangoma Technologies Corp. A200/Remora FXO/FXS Analog AFT card


After giving ztcfg -vvv command its shows the following error:

ZT_SPANCONFIG failed on span 1: No such device or address (6)

More over in /proc/zaptel/1 it shows nothing after configuring the channel..

[lerroux]

are you sure you installed the hardware correctly?

and also, what kind of signalling are you using?

can you post some more details? software version, hardware models etc.

[mtk_400]

driver for sangoma a101d ...wanpipe 3.5.4

vicidial now.2.0.5


signalling type.....pri_cpe

[gardo]

Have you configured your Sangoma card properly? Have you run "wancfg_zaptel"?

[mtk_400]

Dear Gardo,

I think there is a problem in driver installation from wanpipe tar file with vicidial ..could u plz help me

I install wanpipe rpm with vicidial now which works fine

[gardo]

Google is our friend. Check this out: http://wiki.sangoma.com/wanpipe-asterisk-configure .