vicidial.org

bonjour je suis entrain de configurer un serveur vicidial mais ça marche est ce que il y a quelqu'un qui peu m’aide
voila ma configuration
passerelle 192.168.1.1

configuration Carriers
register => xxxxxx:yyyyyyyyy@000.000.000.0:5060/xxxxxx
[goautodial]
Disallow=all
Allow=g729
allow=alaw
allow=ulaw
Type=friend
Username=xxxxxx
Secret=yyyyyyyyy
Host=000.000.000.0
dtmfmode=inband
qualify=1000
context=trunkinbound
canreinvite=no
nat=yes

Dialplan Entry

exten => _91XXXXXXXXXX,1,AGI(agi://127.0.0.1:4577/call_log)
exten => _91XXXXXXXXXX,2,Dial(SIP/${goautodial}/${EXTEN:1},,tTo}
exten => _91XXXXXXXXXX,3,Hangup

je travail avec une compagne ratio
le problème que les appels ne sorte pas
plz help me

1) Welcome to the party!

2) when you post, please post your entire configuration including (but not limited to) your installation method and vicidial version with build.

this IS a requirement for posting along with reading the stickies (at the top of each forum) and the manager's manual (available on EFLO.net, both free and paid versions)

You should also post: Asterisk version, telephony hardware (model number is helpful here), cluster information if you have one, and whether any other software is installed in the box. If your installation method is "from scratch" you must post your operating system and should also post the .iso version from which you installed your original operating system.

Similar to This:

Vicibox X.X from .iso | Vicidial X.X.X-XXX Build XXXXXX-XXXX | Asterisk X.X.X | Single Server | No Digium/Sangoma Hardware | No Extra Software After Installation

3) English Dude! LOL

4) Does your trunk register?

Code: Select all

sip show registry


5) Did you remember to change the carrier to Active = "Y"? LOL

6) Show Asterisk CLI output from a call attempt

Code: Select all

asterisk -R
core set verbose 4

goautodial 2.1, Vicidial 2.4b0.5, asterisk 1.4.39.1-vici
I used to install and configure this version, but this is the first time I change the private address.
I change the server ip.
but its not working
tks

I ran the update command update_server_ip, c good now