Page 1 of 1

Min Machine Conf Required?

PostPosted: Tue Jul 01, 2008 9:05 pm
by kolucoms6
I want to use Vicidialnow for 10 agents.

What is the Minimum Machine Conf Required ?

Can I use P4 with 2.8 Ghz and 1 GB Ram with 2 network cards ?

PostPosted: Tue Jul 01, 2008 9:21 pm
by kolucoms6
Also, FYI , we will record on individual system and not on server or P4 mahcine.

PostPosted: Thu Jul 03, 2008 4:02 am
by kolucoms6
Any Expert Comments ?

PostPosted: Thu Jul 03, 2008 4:23 am
by mflorell
Please do not post the same question in more than one forum section.

If you had searched around the forums before posting your question you would know that we always ask all sorts of questions like:

- full recording of all calls?
- maximum lines to agent ratio?
- if using SIP, what codec?

PostPosted: Thu Jul 10, 2008 3:31 am
by kolucoms6


- full recording of all calls? --> Yes b ut on Agent PC only. Not on server
- maximum lines to agent ratio? --> 3: 1
- if using SIP, what codec? : G729 or G711 . I can use both Xlite and Eyebeam.


PostPosted: Thu Jul 10, 2008 10:47 am
by kissas
why do you record in the agent pc?
and how?

PostPosted: Thu Jul 10, 2008 2:37 pm
by kolucoms6

why do you record in the agent pc?



as My server capability is limited..

and how?


AutoRecord feature of Xlite !!

Card

PostPosted: Sun Jul 13, 2008 8:14 am
by kolucoms6
Also, do I need Dialogic Card in my server ?

PostPosted: Sun Jul 13, 2008 11:47 am
by gardo
If you're going to use VoIP, you don't need any Dialogic, Digium or Sangoma cards. However, it is highly recommended to get a hardware based timer for your system. You can get an x100p card from http://www.x100p.com for around $29.

If you want to run with 10 agents on a single box using VicidialNOW, here are the recommended specs:

AMD X2 3800 or Intel Core 2 Duo e6400 or higher
2 gig of RAM (4 gig is better if you will use RAMDRIVES)
320 gig HD
x100p card

I would also recommend you wait for the 1.1 final release of VicidialNOW (scheduled this month). This has lots of technical improvements over the previous releases like kernel preemption set to server, fully rpm based system and a graphical installation method among others.

PostPosted: Sun Jul 13, 2008 12:27 pm
by kolucoms6
hardware based timer reqd for ?

PostPosted: Sun Jul 13, 2008 1:11 pm
by gardo
Asterisk meetme rooms.