vicidial.org

First off I would like to thank Mr Florell and all others that have given there knowledge to us to make ViciDial a successful platform for all to use.

I have a single server with ViciDialNOW installed. I also have the TE100P T1 card installed. My question is this: Would I be able plug the TE100P into the PRI jack and just go??

I'm assuming the defaults on this card are the following:

Central Office: NI-2
Framing: ESF
Line Code: B8ZS

Thanks for your help.

You have to configure the card.

You have to modprobe it then edit zaptel.conf and zapata.conf

There is a lot of talent here, and some even have time to jump on and help out but ... if you want a larger pool of helpers a little more directly related to your question:

This is a matter of interfacing with your PRI provider and the place from which you purchased your TE100P. Between the two of them, they should be very happy salespeople and walk you through the process.

Then your next level is the digium site where discussions of this topic are expected (after all, it is their equipment and every time one sells it must be installed).

After it is working with asterisk, of course, it will work with vicidial.