Page 1 of 1
ViciBox Redux v.2.0.1 maintenance release
Posted:
Mon Jul 05, 2010 11:16 amby Kumba
Changes Made:
- Modified Config.pm to remove the failing/funky internap CPAN repo
- Corrected a chown command on the VTiger directory
- Hopefully the new build corrects the GPG keys from the OpenSuSE repo forking
Posted:
Mon Jul 05, 2010 8:07 pmby unicorncn
When F6 install driver, there is no progress to do this during installation.
Posted:
Fri Jul 09, 2010 12:26 pmby Kumba
You would want to consult the Instructions for the driver you are trying to load or the OpenSuSE general install instructions on how to load third party drivers. Using hardware that isn't supported by the v.2.6.27 kernel was beyond the scope of that install document.
Posted:
Mon Jul 12, 2010 3:46 amby unicorncn
Thanks, I have a problem with install the drive for there is no drive for Opensuse, I use PIKE 6480. I find the kernel 2.6.27 include PIKE6440 only. And kernel 2.6.31 (OpenSuse 11.2) include this drive. If you have any advice to upgrade from 11.1 to 11.2, or if you have any plan to build vicibox with 11.2 for it support more hardware? I try to build kernel order your sample, but get always some error. Thanks a lot.
Posted:
Mon Jul 12, 2010 8:48 amby mflorell
Have you tried the SuSE Enterprise driver with openSuSE?
Posted:
Wed Jul 14, 2010 10:38 pmby unicorncn
I success take the kernel build driver from SLSE 11.2 into vicibox. It need rebuild kernel once under 2.6.27.45-0.1.
Thanks mflorell.
Posted:
Thu Jul 15, 2010 2:20 pmby Kumba
The next version of ViciBox Redux will more then likely be built on OpenSuSE v.11.3 that just came out today. I believe it's running kernel 2.6.34.
Posted:
Thu Jul 22, 2010 5:57 pmby thirdhatch
Is 2.0.1 is now broken due to some issues with Dahdi?
I tried installing it today on a new system and it failed compiling Asterisk. Here is a log of the error:
***********************************************************
The existing menuselect.makeopts file did not specify
that 'app_dahdibarge' should not be included. However, either some
dependencies for this module were not found or a
conflict exists.
Either run 'make menuselect' or remove the existing
menuselect.makeopts file to resolve this issue.
***********************************************************
make: *** [menuselect.makeopts] Error 255
ERROR! ERROR! Something has gone horribly wrong! Processing stopped!
Failure Area : Could not compile Asterisk.
Thanks,
Bill