Forward DID number to another DID

[richardroi]

On my DID settings how can I forward a DID number to another DID? What settings do I need to edit?
Thank you.

[williamconley]

Route the DID to a call menu with no prompot and a menu timeout of "0" (or "1"? test that ... if you can't use "0" you can always use the time check feature instead). Route the call menu to an "extension" (which would be the target DID) with "Context" of "trunkinbound". Not sure what'll happen your your CID (depends a bit on the version you're using ...), but it should work nicely. Post back and let us know.

[striker]

DO you want to forward to a DID in same system or DID registered in another system?

[richardroi]

Forward DID in the same system.
any more ideas?
BTW. Thanks William.

[perci100]

I would just route the DID to an extension then (if you are dialing in the US ) place 91xxxxxxxxxx (replace the x's with your number) in the extension box. There may be better ways to do this but that is what I usually do. I guess if its in the same system you might not want to go that route to save on the LD. My 2 cents at least hope this helps

[richardroi]

Route the DID to a call menu with no prompot and a menu timeout of "0" (or "1"? test that ... if you can't use "0" you can always use the time check feature instead). Route the call menu to an "extension" (which would be the target DID) with "Context" of "trunkinbound". Not sure what'll happen your your CID (depends a bit on the version you're using ...), but it should work nicely. Post back and let us know.

Busy Tone!

[Mar 13 00:59:52] WARNING[14480]: pbx.c:10008 pbx_builtin_background: Background requires an argument (filename)

Kindly advice.

Thank you.

[richardroi]

After I put a recording on menu prompt.
Auto fallthrough, channel 'SIP/voipxxxxxxxxx-00000ecb' status is 'UNKNOWN' ---