Absolute new installation and DAHDI dead.

[kvar]

I have just finished a fresh installation of ViciBox_v9.x86_64-9.0.3.iso

I am on Installation manual page 7 : ViciDial Express Installation

There are no logged errors
Clean reboot
I have logged in vicidial administration page succesfully

Before start the next configuration steps I had a look on the status of DAHDI:

vicibox9:/home/kvar # /etc/init.d/dahdi status
Checking for dahdi ... modules loaded. running
● dahdi.service - LSB: Load and initialize Dahdi.
Loaded: loaded (/etc/init.d/dahdi; generated; vendor preset: disabled)
Active: inactive (dead)
Docs: man:systemd-sysv-generator(8)
vicibox9:/home/kvar # /etc/init.d/dahdi start
redirecting to systemctl start dahdi.service
vicibox9:/home/kvar # /etc/init.d/dahdi status
Checking for dahdi ... modules loaded. running
● dahdi.service - LSB: Load and initialize Dahdi.
Loaded: loaded (/etc/init.d/dahdi; generated; vendor preset: disabled)
Active: active (exited) since Sat 2020-07-04 22:49:32 EEST; 7s ago
Docs: man:systemd-sysv-generator(8)
Process: 3354 ExecStart=/etc/init.d/dahdi start (code=exited, status=0/SUCCESS)
vicibox9:/home/kvar #

Is that normal? Please advice before continue all the next configuration steps.

Thank you.

[carpenox]

Service dahdi enable

[kvar]

Finally I found that the following status of DAHDI module means that it is working.
The campaign call succeded.

/home/kvar # /etc/init.d/dahdi status
Checking for dahdi ... modules loaded. running
● dahdi.service - LSB: Load and initialize Dahdi.
Loaded: loaded (/etc/init.d/dahdi; generated; vendor preset: disabled)
Active: active (exited) since Sat 2020-07-04 22:49:32 EEST; 7s ago

[carpenox]

Good postback, glad everything is working for ya

[Kumba]

So dahdi is loaded by the vicidial init script, not the dahdi init script.

After you ran vicibox-install, did you reboot? If you didn't, that's why DAHDI wasn't loaded.