how can I setup an agent only server in my cluster?

[kashinc]

Hey Guys,

I have gone back and fourth with Asterisk13 and Asterisk11, I have even attempted to AMD AGENT ROUTE METHOD with only
HUMAN,HUMAN
NOTSURE,TOOLONG
turned on, I am still getting A LOT of dead air calls.

When I switch back to Asterisk 11 its almost cut in half, I think maybe Asterisk 13 just takes more resources because it works just fine until the channels really start to shoot up.

I want to setup 3 servers that will only be agent servers running asterisk 13 so I can use webrtc but then use the asterisk 11 servers to dial only. I have not had any luck doing this because even if I turn off Balance Dialing on the asterisk 13 agent servers it still uses them to dial out.

How would I go about just using the Asterisk 13 servers as only agent servers that don't outbound with the rest of my asterisk11 servers. The only thing I have not tested is during the install of the server to not install it as a telephony server, but I am not sure.

Any help would be much appreciated.

-Kashinc

[dhijrwn]

set the server max trunk to 0 then disable the balance dial then enable the agent asterisk and that it will make agent only.

[pikalla]

hello as I said said the last time I was able to carry out the connectivity tests thanks to your following tip
and I access the myql interface by typing your command mysql -h 151.232.34.222 -u cron -p1234
but I encountered a problem when connecting my agent to its interface, its returned me the following message: Sorry, there are no available sessions: || 151.172.33.153 | 1000 | SIP / 1000 |
at the level of the agent connection interface I am installing on two remote servers I am not locally merxi well helped me