Digium 1TE135F and 1TE235F default to T1 after reboot

[worseo]

Hello Team,
I need assistance. I have installed vicibox successfully on the below server spec.
Dell PowerEdge R720 and 740 with 32 and 16 GB rams respectively. 1T drives raid1.

Each time I run the dahdi_genconf or reboot the server, the dahdi_scan show T1 instead of E1 for both servers.

How do I configure the card to stay in E1 mode?

dialer02:~ # cat /etc/asterisk/dahdi-channels.conf
; Autogenerated by /usr/sbin/dahdi_genconf on Fri Nov 5 13:48:55 2021
; If you edit this file and execute /usr/sbin/dahdi_genconf again,
; your manual changes will be LOST.
; Dahdi Channels Configurations (chan_dahdi.conf)
;
; This is not intended to be a complete chan_dahdi.conf. Rather, it is intended
; to be #include-d by /etc/chan_dahdi.conf that will include the global settings
;

; Span 1: WCTE2/0/1 "WCTE23X (PCI) Card 0 Span 1" (MASTER) ESF/B8ZS RED
group=0,11
context=from-pstn
switchtype = national
signalling = pri_cpe
channel => 1-23
context = default
group = 63

; Span 2: WCTE2/0/2 "WCTE23X (PCI) Card 0 Span 2" ESF/B8ZS RED
group=0,12
context=from-pstn
switchtype = national
signalling = pri_cpe
channel => 25-47
context = default
group = 63


dialer02:~ # cat /etc/dahdi/system.conf
# Autogenerated by /usr/sbin/dahdi_genconf on Fri Nov 5 13:48:55 2021
# If you edit this file and execute /usr/sbin/dahdi_genconf again,
# your manual changes will be LOST.
# Dahdi Configuration File
#
# This file is parsed by the Dahdi Configurator, dahdi_cfg
#
# Span 1: WCTE2/0/1 "WCTE23X (PCI) Card 0 Span 1" (MASTER) ESF/B8ZS RED
span=1,1,0,esf,b8zs
# termtype: te
bchan=1-31
dchan=32
echocanceller=mg2,1-31

# Span 2: WCTE2/0/2 "WCTE23X (PCI) Card 0 Span 2" ESF/B8ZS RED
span=2,2,0,esf,b8zs
# termtype: te
bchan=32-60
dchan=62
echocanceller=mg2,32-60

# Global data

loadzone = us
defaultzone = us

[ambiorixg12]

This post might help you https://community.asterisk.org/t/dahdi- ... ot/39395/4