HI follow this to install sangoma PRI card

[arunkoods]

Hi ,
just follow this steps and you can just install sangoma PRI card for VICIDIAL

***********************************************************
1) Copy the package wanpipe-3.3.10 through ftp/tunnelier in to the src directory (/usr/src)


2) Login to the server via SSH (using putty)

TYPE:-

cd /usr/src
tar -zxvf wanpipe-3.3.10
cd wanpipe-3.3.10
./Setup install

3) After giving the above command check all the rpm packages are installed in the server. If some of the packages are FAILED use the below command to
install the packages.

TYPE:-

yum install bison-devel bison libtermcap-devel gcc-c++ newt-devel libtool gnutls-devel bash2 gawk byacc flex

4) After installation of the rpm packages required for installation of Sangoma PRI card run the ./Setup install command again.

TYPE:
Y
ENTER
Y
ENTER
ENTER
Y
2
m
----
Enter zaptel path manually

For this type in the zaptel path manually (astC30- TYPE IN:- /usr/local/src/zaptel-1.2.24)---Alternate checking for zaptel drivers is to open another SSH (via putty) then TYPE locate zaptel. Among the searches choose the /usr/src/local/zaptel 1.2XX.etc.)

Y
Y
Y
ENTER
ENTER
ENTER
ENTER
Y
Y
Y
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
Y
-----------------

Now configure the zaptel drivers---

1
2
2
1
2
1
1
5
1
1
ENTER
ENTER
ENTER
1
1
1
--------------------------


5) Connect the cable and check the PRI card status by TYPING

wanpipemon -i w1g1 -c Ta -- for checking the wanpipe status

zttool --- to check the status of main Connection OK/RED

*****************************************************

its done.
NOTE: these instructions are only for Redhat/Fedora/Centos, which by the way we do not recommen using.

[mflorell]

You should mention that these instructions are only for Redhat/Fedora/Centos, which by the way we do not recommen using.

[arunkoods]

Thanks and i am sorry for not mentioning it.

[gmcust3]

But these steps will "definitely" help others who are using VNow

May be ViciNow team can make it as Sticky under ViciDialNOW category !!!

Same steps are applicable for GSM PRI ?

[gardo]

The latest VicidialNOW (1.3) comes with out of the box Sangoma cards (PRI, TDM, and etc) support. Just enter "wanconfig" or "wancfg" on the command prompt and configure your Sangoma card. Wanpipe 3.5.8 is installed by default.

[gmcust3]

Same steps are applicable for GSM PRI ?