vicidial.org

by **mel0683** » Wed Feb 14, 2007 1:33 pm

hi guys

what alternative digium card aside to this one?Digium Wildcard Single Span T1 Card T100P..

thank u.
beginner

by **mflorell** » Wed Feb 14, 2007 10:24 pm

The T100P has been retired, and the replacement is the TE110P.

The alternatives to using Digium cards are Sangoma a101 and Rhino single T1 card.

by **mel0683** » Thu Feb 15, 2007 2:04 pm

how about X100P?this specs Asterisk OEM X100P FXO PCI Card
co'z i purchased this device.its possible to run in vicidial?

thanks

by **mflorell** » Thu Feb 15, 2007 3:31 pm

The X100P card is only an analog POTS line card, not a T1/E1 card. But if you just need a timer for zaptel/meetme, it will work very well.

by **mel0683** » Thu Feb 15, 2007 6:09 pm

really its only used for timer of zaptel/meetme only?
so what device can i use to setup a vicidial to have a predictive dialer?

by **mflorell** » Fri Feb 16, 2007 12:10 am

For only a timer, then the X100P card will work great. I recommend getting them on ebay or x100p.com

by **eijal** » Wed Mar 07, 2007 5:51 pm

What about dialogic cards?
I have one, but I only found that it works with special drivers from DIGIUM (paying). I was looking how to buy that driver, but I can't find anything.
Anyone has experience with this cards (just for timer) my model is: D/41JCT-LS.

PD.
I want to use it only like a timer

by **Op3r** » Wed Mar 07, 2007 6:23 pm

Just buy an x100p for your timer needs. its cheap it cost like 15 to 30 usd

by **eijal** » Thu Mar 08, 2007 12:22 pm

Op3r wrote:Just buy an x100p for your timer needs. its cheap it cost like 15 to 30 usd

I have a x100p card, but the problem is that it doesn't feet on my PCI 3.3v interfaces. And it's too expensive to buy a E1/T1 card from DIGIUM, just for timer

by **gerski** » Thu Mar 08, 2007 2:37 pm

Why not use an old pc (p3 or older) and use ur x100p if ur just trying to install it. that way it is much cheaper than buying a T1/E1 card...

by **Op3r** » Thu Mar 08, 2007 2:48 pm

or change your motherboard.

by **eijal** » Thu Mar 08, 2007 4:26 pm

I can't use a P3 or an old motherboard, because I am designing a predictive dialer for 15 agent. And imposible that a P3 or an old motherboard can support that load

by **Op3r** » Thu Mar 08, 2007 8:41 pm

then buy a new motherboard.

a new motherboard only cost like 300 usd (which is a very good one)

vicidial.org

alternative digium card?

alternative digium card?

DIALOGIC CARDS

Who is online